Anemostat WoodPro Veneer Metal Vision Panel

The standard LoPro is galvanised mild steel, grey primed ready for powder coating. However it is also available as WoodPro™ with unfinished real wood veneers over PVC profiles which fasten to the LoPro metal vision frame with double sided adhesive tape. The veneers conceal the frame screw fixings and are available red oak, mahogany and maple.

Note: for internal use only.

MATERIAL
20 GA cold rolled steel frame. PVC and wood veneer.

FINISH
Unfinished red oak, maple or mahogany veneers over beige enamel LoPro.

SIZES
Minimum width of door cut-out 102mm. Maximum height of door cut-out 1829mm. Sizes available in inch increments, not available in fractional sizes.

INSTALLATION
WoodPro™ is easy to install and provides a low profile, flush to the door real wood finish. Uses 44mm sheet metal screws that pass through the door cut-out, and fastens to the opposite side of the vision frame. The formed wood veneers are pre-mitred with self-adhesive tape for ease of installation. Wood putty or putty stick may be required at mitres to fill any small gaps.

DOOR THICKNESS
For 44-46mm metal or timber doors. Not available to suit other door thicknesses.

GLASS THICKNESS
6mm as standard. Glass pocket of 10mm allows for glazing tape or compound to be used on one or both sides of the glass.

AESTHETICS
No visible screws once veneers are in place. Tight mitred corners, bevelled glass stop and low profile, provide a clean tapered look.

FIRE RATINGS
Tested for 30 minutes on timber door to BS EN 1634-1:2008. Actual size tested 410mm x 711mm.